ICE COBOTICS i-Synergy RS28L-CY, Руководство оператора

Страница: 7 / 45

ICE RS28L-CY 7
OPERATOR MANUAL
i-synergy
TM
collects operational data from
cleaning machines and transmit the information
to ICE’s server. The ICE server generates daily
reports and send them to designated end users
by email. From these reports, end users will
have information about machines’ usage and
even specific timings.
Besides, i-synergy TM also collects data on
lithium-ion battery, vacuum motor, brush
deck motor, transaxle, and other electrical
components at least once every minute when
the machine is in use and even during battery
charging.
i-synergy TM will send notifications instantly
to the ICE server in case of any malfunction.
ICE maintenance personnel will receive a
SMS within minutes from the ICE server for
immediate servicing.
UNCRATING MACHINE
Be sure and check packing carton for any damage.
Immediately report any damage to carrier. Check
the contents of package to ensure that the
following items are included:
• Machine
• Lithium-ion Batteries
• Squeegee assembly
• 2-Cylinderical Brushes
1. Uncrate the wooden box, place the top board
on the edge of pallet, lie in the front of the
machine, as below shown.
WARNING: Do
not operate machine unless
you have read & understood this manual.
2. Install batteries.(see INSTALLING BATTERIES )
3. Place the ID card on the scanning area (Machine
components, #15) to turn on the machine,
make sure the Squeegee assembly (Machine
components, #4) and the Cylinderical assembly
(Machine components, #6) is off the floor.
4. Sit in the Operator seat (Machine components,
#12), hold the Steering wheel (Machine
components, #13), press the Propel pedal
(Machine components, #10) and driving slowly
the machine down from the slope.
INSTALLING BATTERIES
The machine uses the Lithium-ion batteries,
the batteries are already in the machine upon
delivery; However you will need to connect the
Lithium ion batteries to the machine.
WARNING: Fire or Explosion Hazard.
Keep sparks and open flames away! Keep
battery compartment open when charging.
1. Turn off the machine.
2. Open and prop up the Operator seat, plug the
batteries connector to the machine adaptor,
connect machine i-synergy
TM
COM port to the
batteries.
INSTALLING BRUSH
1. Turn off the 1-Step staring button (Machine
components, #31) and raise the cylinderical
assembly off the floor, then stop machine on the
level surface, ensure the machine is turned off.
2. Remove Brush door from the Cylinderical scrub
head assembly by loosening the knob.
3. Attach brush door to the brush end that has the
double row of brushes to install bursh.
4. Check the brushes to ensure they are properly
adjusted.
INSPECT THE BRUSH PATTERN
After installing a new set of cylindrical brushes
check the brush pattern to ensure proper brush
adjustment.
1. Measure the distance from the front edge
of the scrub head to the floor and from the
back edge of the scrub head to the floor.The
measurements should be the same.
2. To level the scrub head, loosening the Lock Nut
and the Hex Nut, adjusting the Knob to adjust
the Cylinderical head properly, and then tighten
them when adjusting finished.
MACHINE SET UP & INSTALLATION
i-synergy
TM
INTRODUCTION