iCanTek iCanView 222, Руководство пользователя

Страница: 12 / 60

iCanView222 User’s Guide
Do not apply power through this power input when Standard PoE connection is used.
y
ALARM IN/OUT and Composite Video Output: Used for connecting P/T device, sensor,
and alarm devices to iCanView222. Note that the bottom most pin is numbered as 1. Pin
assignments are as follows
Pin Description Misc.
1 SNS IN (+) Sensor In (+). NC/NO selectable in
admin mode.
2 SNS In (-) Sensor In (-). NC/NO selectable in
admin mode.
3 CVBS OUT(+) Composite video output
4 CVBS OUT(-) Ground for composite video output
5 RLY OUT Relay output : closed circuit in alarm
to indicate alarm status
6 RLY OUT
.
„
SNS IN : Connect external alarm sensors such as the infrared sensors, heat sensor,
magnetic sensors, etc. NC/NO selectable in the admin page.
„
RLY OUT : It is used for connecting external alarm generators such as sirens,
flashing light, etc. When activated, relay output configures a closed circuit.
Please refer to Section 6.1 for more detailed description on the Alarm In/Out
connections.
y
Reset : Factory Default Switch
There is a switch provided for returning the network camera to factory default state. Open the
dome cover to access the switch. Press the switch through a tiny hole using tools with sharp
tip for a few seconds while power is applied.
2.4. PC Requirements
AV streaming data received from iCanView222 can be decoded or stored in a PC running i-NVR
program which is a viewing & recording program for a PC. Minimum requirement of the PC is
described below:
Rev.1.0 (Mar. 2008)
12