IBM xSeries 230 61Y, Руководство по техническому обслуживанию аппаратной части

Страница: 91 / 194

4. From the Start menu, select the Run option.
5.
Type A:\SETUP.EXE in the Open box.
6. Click OK . The Setup wizard opens.
7. Follow the instructions given by the setup wizard until the program is
installed.
Windows NT Server failover setup: To install the IBM Netfinity 10/100 Fault
Tolerant Adapter device drivers:
1. Add the redundant NIC adapter according to the instructions that are provided
with the adapter.
2.
Use the ServerGuide CDs to install the AMD PCNet Ethernet Family adapter
device driver.
3. Do not select the Grouping box at this point; you must first restart the machine.
4.
From the Windows NT Server desktop, select Control Panel , then select the
Network icon, then select the Adapters tab.
5. Highlight one of the adapters that will be in the redundant pair and then click
the Properties... button.
6. Check the Grouping box. This will show the possible combinations for
redundant pairs.
7. Select the adapter pair you want and then select OK . Note that the integrated
Ethernet controller is located at PCI bus A, slot 2.
Two options are available for recovering from a failover condition. The options
are determined by the Enable for DMI / Hot Swap Support checkbox. If the
IBM Netfinity Hot Plug PCI for Windows NT Server 4.0 package is installed,
this checkbox will appear at the bottom of the Adapter Properties panel. If you
do not have the IBM Netfinity Hot Plug PCI for Windows NT Server 4.0
package installed on your server, you will not see the Enable for DMI / Hot
Swap Support checkbox.
If the Enable for DMI / Hot Swap Support checkbox is not checked or is not
present, traffic will automatically switch back to the primary adapter when the
primary link status is restored. In this mode, the adapter cannot be
hot-swapped. Users with the IBM Netfinity Hot Plug PCI for Windows NT
Server 4.0 package installed should check the Enable for DMI / Hot Swap
Support checkbox.
If the Enable for DMI / Hot Swap Support checkbox is checked, traffic will
remain on the secondary adapter until the user directs it to return to the
primary adapter. This can be done after the hot-swap replacement of the
primary adapter or by using the DMI interface.
8. Select Close to exit from the Network setup.
When you restart the server, the failover function will be in effect.
If a failover occurs, a message is written to the NT Event Viewer log. In addition, if
the Enable for DMI / Hot Swap Support checkbox is checked, a DMI alert will also
be generated.
IntraNetWare:
1. Add the redundant NIC adapter according to the instructions that are provided
with the adapter.
2.
Load the device driver by using the following command:
LOAD d :\ path \PCNTNW.LAN PRIMARY= x SECONDARY= y
Installing options
83