IBM xSeries 230 61Y, Руководство по техническому обслуживанию аппаратной части

Страница: 57 / 194

Removing the left-side cover (tower model)
Note: To remove or install a hot-swap hard disk drive or hot-swap power supply,
it is not necessary to remove the cover.
1
Cover release lever
2
Left-side cover
To remove the left-side cover of the tower model:
1. Review the information in “Before you begin” on page 47.
2.
If you are planning to install or remove any part other than a hot-swap hard
disk drive or hot-swap power supply, turn off the server and all attached
devices and disconnect all external cables and power cords.
3. Slide the cover-release lever on the front of the server to release the cover; then,
slide the cover toward the rear of the server about 25 mm (1 inch). Move the
top edge of the cover out from the server; then, lift the cover off the server. Set
the cover aside.
Attention: For proper cooling and airflow, replace the cover before turning
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
Removing the cover (rack model)
Note: To remove or install a hot-swap hard disk drive or hot-swap power supply,
it is not necessary to remove the cover.
Installing options
49