IBM xSeries 200VL, Руководство по установке

Страница: 30 / 70

18
IBM xSeries 200 and xSeries 200VL: Installation Guide
11. Replace the support-bracket assembly and reconnect the fan cable to the
connector (SYSFA3) on the system board. See “System board internal cable
connectors” on page 5 for the location of the fan cable connector.
12. If you have other options to install, do so now.
13. Reinstall the side cover. See “Installing the cover” on page 22 for details.
14. Reconnect the external cables and power cords; then, turn on the peripheral
devices and the server.
Installing a hard disk drive in bay 5, 6, or 7
Complete the following steps to install a hard disk drive in bay 5, 6, or 7.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 3.
1. Review the safety precautions listed in “Safety” on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the cover (see “Removing the side cover” on page 9
for details).
3. Remove the support-bracket assembly and disconnect the fan cable from the
connector (SYSFA3) on the system board. See “Removing the support-bracket
assembly” on page 10 for details. See “System board internal cable connectors”
on page 5 for the location of the fan cable connector.
4. Access the drive cage.
a. If your server has hard disk drives installed in the drive cage, disconnect the
power and signal cables from the rear of the drives.
b. Rotate the drive cage out of the server until it locks into place over the drive
cage retention tab.
Drive cage release tab
Drive cage retention tab