IBM X 330 Series, Руководство по установке

Страница: 50 / 76

38
IBM xSeries 330 Type 8675: Installation Guide
Option problems Verify that:
• The option is designed for the server. See the "Server Support" flowchart for
information about obtaining ServerProven™ compatibility information from the
World Wide Web.
• You followed the installation instructions that came with the option.
• The option is installed correctly.
• You have not loosened any other installed options or cables.
• You updated the configuration information in the Configuration/Setup Utility
program. Whenever memory or an option is changed, you must update the
configuration.
If the problem remains, call for service.
An IBM option that was just
installed does not work.
An IBM option that used to work
does not work now. Verify that all of the option hardware and cable connections are secure.
If the option comes with its own test instructions, use those instructions to test the
option.
If the failing option is a SCSI option, verify that:
• The cables for all external SCSI options are connected correctly.
• The last option in each SCSI chain, or the end of the SCSI cable, is terminated
correctly.
• Any external SCSI option is turned on. You must turn on an external SCSI option
before turning on the server.
If the problem remains, call for service.
Power problems Verify that:
• The power cables are properly connected to the server.
• The electrical outlet functions properly.
• The type of memory installed is correct.
• If you just installed an option, remove it, and restart the server. If the server now
powers on, you might have installed more options than the power supply
supports.
If the problem remains, call for service.
The server does not power on.
The server does not power off. Verify if you are using an ACPI or non-ACPI operating system.
If you are using a non-ACPI operating system:
1. Press Ctrl+Alt+Delete.
2. Turn off the system by using the power-control button.
If the problem remains or if you are using an ACPI-aware operating system, call for
service.
Serial port problems Verify that:
• Each port is assigned a unique address by the Configuration/Setup Utility
program and none of the serial ports is disabled.
Note: The Management connector is the same as a serial port connector, but it
is used only by the integrated ASM processor and is not available for use
by the operating system. This port does not appear in the
Configuration/Setup Utility program menus. It can be configured using
IBM Director.
• The serial-port adapter, if you installed one, is seated properly.
If the problem remains, call for service.
The number of serial ports
identified by the operating
system is less than the number
of serial ports installed.
Table 6. Troubleshooting charts.
Symptom Suggested action