IBM X 330 Series, Руководство по установке

Страница: 26 / 76

14
IBM xSeries 330 Type 8675: Installation Guide
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 3.
Complete the following steps to install a microprocessor:
1. Review the safety precautions beginning on page v.
2. If the server is running an operating system, shut down the operating system and
then turn off the server and peripheral devices.
3. Remove all power cords and external cables from the server; then, remove the
server cover. For more information on removing the cover, see “Removing the
cover” on page 5.
4. Lift up the microprocessor release lever and remove the terminator card from the
microprocessor connector.
5. Orient the microprocessor over the microprocessor connector as shown in the
following illustration. Carefully press the microprocessor into the connector.
Attention: To avoid bending the pins, do not use excessive force.
6. Push the release lever down to lock the microprocessor into place.
7. Install the heat sink onto the microprocessor.
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure that
the square of thermal material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor.
Note: Locate the slot in the channel of the heat sink. Orient the heat sink so
that the slot will be at the rear of the server.
c. Align and place the clip over the heat sink; then, snap the clip into place over
the heat sink with the heat-sink release lever in the up position.
Note: If you remove the microprocessor later, remember to install the
terminator card in the appropriate microprocessor connector.
d. When the clip is in place, press the heat-sink lever down into the locked
position.
Rear of server
Microprocessor
Microprocessor
connector
Microprocessor
orientation indicator
Microprocessor-
release lever