IBM Ultrastar 36LZX, Технические характеристики

Страница: 58 / 249

8.1 SCSI Control Byte
The Control Byte is the last byte of every CDB. The format of this byte is shown below.
LINK FLAG Reserved = 0 VU = 0
0 1 2 3 4 5 6 7
Bit
Figure 49. SCSI Control Byte
VU VU stands for Vendor Unique.
FLAG The Flag bit specifies which message the target shall return to the initiator if the link bit is one
and the command completes without any error. If Link is zero, Flag must also be zero. If Link
is one and the command terminates successfully, the drive will send either the LINKED
COMMAND COMPLETE message (FLAG=0) or the LINKED COMMAND COMPLETE WITH
FLAG message (FLAG=1). Typically this bit is used to cause an interrupt in the initiator
between linked commands.
LINK This bit is set to one to indicate that the initiator desires an automatic link to the next
command upon successful completion of the current command. Upon successful completion
of the command, the drive will return INTERMEDIATE GOOD status and then send one of the
two messages defined under Flag above.
Upon unsuccessful completion of the command, the drive will return CHECK CONDITION
status or RESERVATION CONFLICT status and then send the COMMAND COMPLETE
message. No further commands in the chain are executed
.
8.2 Abbreviations
These abbreviations are used throughout the following sections.
LUN Logical Unit Number. An encoded three bit identifier for the logical unit
VU Vendor Unique bits
LBA Logical Block Address
RSVD Reserved
MSB Most Significant bit
LSB Least Significant bit
8.3 Byte ordering conventions
In this specification, where it is not explicitly stated, all multibyte values are stored with the most
significant byte first. For example in a 4 byte field byte 0 will contain the MSB and byte 3 the LSB.
Ultrastar 36LZX hard disk drive specifications
58