IBM TotalStorage IP Storage 200i 110, Руководство по установке

Страница: 32 / 94

5. Remove the adapter from the static-protective package holding the controller
by the edges. Do not touch any exposed components or gold-edge
connections on the controller.
6. Carefully grasp the adapter by its top edge or upper corners and align it with
the expansion slot on the system board.
7. Press the adapter firmly into the expansion slot.
Attention: When you install an adapter in the engine, be sure that it is
completely and correctly seated in the system-board connector before you
apply power. Incomplete insertion might cause damage to the system board or
the adapter.
8. Align the bottom tabs of the adapter-retention bracket with the holes at the top
of the expansion slots, and press the adapter-retention bracket toward the
back of the engine until it clicks into the locked position.
9. Align the bottom tabs of the adapter-support bracket with the holes on the side
of the fan assembly, and press the adapter-support bracket toward the front of
the engine until it clicks into the locked position.
10. Replace the cover (see “Replacing the cover” on page 17) and plug in the
power cords and network cables (see “Attaching network cables”).
11. Power ON the appliance. The PCI BIOS automatically assigns resources to the
adapter.
Attaching network cables
This section describes how to attach the network cable to a Gigabit Ethernet
Copper Adapter or Gigabit Ethernet SX Adapter.
Gigabit Ethernet Copper Adapter: Insert the Category 5 twisted-pair RJ-45
network cable into the adapter’s connector.
ACT
10/10
0/0
00
TX
LIN
K
Figure 6. Attaching a Gigabit Ethernet Copper Adapter
20
IBM TotalStorage IP Storage 200i Models 110 and 210 Installation Guide