IBM TotalStorage IP Storage 200i 110, Руководство по установке

Страница: 27 / 94

DANGER
<1–5> Electrical current from power, telephone and communication cables
is hazardous.
To avoid a shock hazard:
v
Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
v
Connect all power cords to a properly wired and grounded electrical
outlet.
v
Connect to properly wired outlets any equipment that will be attached to
this product.
v
When possible, use one hand only to connect or disconnect signal
cables.
v
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
v
Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
v
Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached
devices.
To Connect To Disconnect
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON. 1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
CAUTION:
<2–19> The power control button on the device and the power switch on the
power supply do not turn off the electrical current supplied to the device. The
device also might have more than one power cord. To remove all electrical
current from the device, ensure that all power cords are disconnected from
the power source.
Note: For translations of these safety notices, refer to Safety Information , which
can be found on the Model 210 that was shipped with your appliance.
Chapter 2. Installation procedures
15