IBM TotalStorage FAStT EXP700, Инструкция по установке и эксплуатации

Страница: 36 / 100

4. Place the drive on a level surface.
Continue with “Installing the support rails and the FAStT EXP700 into a rack
cabinet”.
Installing the support rails and the FAStT EXP700 into a rack cabinet
To install the FAStT EXP700 in a rack cabinet, use the rails and rack-mounting
hardware that come with your expansion unit. The FAStT EXP700 requires an EIA
310-D Type A 19-inch rack cabinet. This required rack cabinet has a minimum and
maximum rack depth of 24 inches and 32 inches respectively, which is the distance
between EIA rails, from the front of the rack cabinet to the rear of the rack cabinet.
This rack cabinet conforms to the Electronic Industries Association (EIA) standard.
Where you place the support rails in the cabinet depends on where you intend to
position the expansion unit.
Use the rack mounting installation assembly package that comes with the
expansion unit to locate the rack mounting holes and install the unit into a rack
cabinet. Instructions for removing and replacing the bezel are included in the
Rack
Mounting Template that comes with the expansion unit.
After you install the FAStT EXP700 in a rack cabinet, continue with “Replacing the
FAStT EXP700 CRUs”.
Replacing the FAStT EXP700 CRUs
Complete the following steps to replace the ESM CRUs that you removed:
1. Slide one ESM into the empty slot in the expansion unit. Be sure the levers are
pulled straight out as you slide it in, as shown in Figure 11 on page 17.
Tray handle
Figure 10. Removing drive CRUs
16
IBM TotalStorage FAStT EXP700 Storage Expansion Unit: Installation and User’s Guide