IBM TotalStorage 3534-F08, Руководство по установке

Страница: 33 / 81

b. Verify the alignment of the slides by sliding the switch in and out of the rack.
Any difficulty moving the switch indicates lateral stress or misalignment; if
this occurs, adjust the slide positions until the movement is smooth.
8. Optional step: If the right rack mount bracket and the left rack mount bracket
were installed on the front corners of the switch (see step 4 on page 13), attach
both brackets to the cabinet rack using M5 x 12 screws
7
.
DANGER
An electrical outlet that is not correctly wired could place a hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (1)
9. When you are ready to supply power to the switch, connect the power cable to
the 3534 Model F08 power supply and to a power outlet. (The power supply
does not have an ac switch.)
The 3534 Model F08 automatically runs a POST each time power is supplied to
it.
Attention: Ensure that the power cable is routed so that it is not pinched or
exposed to stress when the switch is moved on the slides.
Note: Do not connect the switch to the network until the IP address is correctly
set or the default IP address is verified as not conflicting with the existing
IP addresses in the same network. For more information, see
“Configuring, connecting, and accessing the 3534 Model F08”.
Configuring, connecting, and accessing the 3534 Model F08
Follow this procedure to configure, connect, and access the 3534 Model F08 for
use in a network fabric.
Time required
Approximately 15 minutes.
SJ000049
Figure 10. Inserting slides into the rack rails
Chapter 3. Installing and configuring the 3534 Model F08
15