IBM TotalStorage 3534-F08, Руководство по установке

Страница: 49 / 81

Note: For dust and electrostatic discharge (ESD) protection, keep the cover on the
serial port whenever it is not in use.
You can use the serial port to connect to a terminal to set the switch IP address
without connecting to the fabric. You can also use it to reinitialize the switch
defaults, which restores the factory configuration and returns the switch passwords
to a known state. The serial ports parameters are 9600 baud, 8 data bits, no parity,
1 stop bit, and no flow control.
The switch requires a straight serial cable with a female 9-pin subminiature-D
connector. Only pins 2, 3, and 5 are supported. If pin 7 is used, this signal must
always be driven high, using the pinouts listed in Table 15.
Table 15. Cabling pinouts if pin 7 is used
Pin Signal Description
1
2 TxData Transmit data
3 RxData Receive data
4
5 GND Logic ground
6
7 CTS Clear to send
8
9
Regulatory specifications
The 3534 Model F08 is certified for the regulatory specifications that are listed in
Table 16.
Table 16. Regulatory specifications
Country or
region Safety specification EMC specification
Canada CSA 22.2 No. 60950 Third Ed. CSA C108.8 Class A
United States UL 60950 Third Ed., Info. Tech. Equip. FCC Part 15, Subpart B,
(CFR title 47) Class A
Japan IEC 60950+A1+A2+A3+A4+A11 VCCI V-3/2000.04, Class
A
International IEC 60950+A1+A2+A3+A4+A11 CISPR22 Class A
Norway Nemko IEC 60950+A1+A2+A3+A4+A11
(CB Report)
Appendix A. Product specifications
31