IBM ThinkCentre 8127, Руководство по техническому обслуживанию аппаратной части

Страница: 18 / 196

v
Readable instructions or the Main Menu.
DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to
002
.
If YES, proceed to
003
.
002
If the Power Management feature is enabled, do the following:
1. Start the IBM Setup Utility program (see “Starting the IBM Setup Utility
program” on page 19)
2.
Select Power Management from the IBM Setup Utility program menu.
3. Select APM .
4.
Be sure APM BIOS Mode is set to Disabled . If it is not, press Left Arrow (
←
) or
Right Arrow (
→
) to change the setting.
5. Select Automatic Hardware Power Management .
6. Set Automatic Hardware Power Management to Disabled .
7. If the problem persists, continue to
003
.
003
Run the Diagnostic programs. See Chapter 4, “IBM Enhanced Diagnostics,” on
page 13.
v
If you receive an error, replace the part that the diagnostic program calls out or
go to “Diagnostic error codes” on page 49.
v
If the test stops and you cannot continue, replace the last device tested.
12
Hardware Maintenance Manual