IBM System x3500 M4, Инструкция по установке и эксплуатации

Страница: 88 / 170

The following illustrations show the location of the drive bays in the 2.5-inch and
3.5-inch hot-swap SAS or hot-swap SATA hard disk drive server models.
The following notes describe the types of drives that the server supports and other
information that you must consider when installing a drive:
v
Make sure that you have all the cables and other equipment that is specified in
the documentation that comes with the drive.
v
Check the instructions that come with the drive to see whether you have to set
any switches or jumpers on the drive. If you are installing a SAS or SATA device,
be sure to set the SAS or SATA ID for that device.
v Optional external tape drives and DVD-ROM drives are examples of
removable-media drives. You can install removable-media drives only in bays 1
and 2 on models with eight 3.5-inch, eight, sixteen, twenty-four, and thirty-two
2.5-inch hard disk drives.
v
The electromagnetic interference (EMI) integrity and cooling of the server are
protected by having all bays and PCI slots covered or occupied. When you install
a drive or PCI adapter, save the EMC shield and filler panel from the bay or the
PCI adapter slot cover in the event that you later remove the drive or adapter.
v
For a complete list of supported options for the server, see http://www.ibm.com/
servers/eserver/serverproven/compat/us/.
Installing a 2.5-inch hot-swap hard disk drive
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
Figure 12. Server with eight 2.5-inch hard disk drives and eight 3.5-inch hard disk drives
70
IBM System x3500 M4 Type 7383: Installation and User’s Guide