IBM System x3105 Type 4347, Руководство пользователя

Страница: 41 / 72

EMC shield
8. Secure the tape drive to the chassis with the supplied screws.
9. Connect the tape drive cable to the tape drive connector on the system board.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 34.
Installing a SATA hard disk drive
The server comes with one Serial ATA (SATA) hard disk drive installed. Before you
install a SATA hard disk drive, read the following information:
v
Read the documentation that comes with the drive for cabling instructions.
v Route the cable before you install the drive. Do not block the airflow from the fan.
v
The server supports two SATA hard disk drives.
Note: Each Serial ATA drive comes with a cable. If you install an additional
Serial ATA drive, you will need an additional cable. If you install an optional
ServeRAID-7t S-ATA controller, all SATA drives must be connected to the
ServeRAID-7t S-ATA controller instead of the system board. The controller comes
with two cables. See the ServeRAID-7t S-ATA controller documentation for
cabling instructions. You can install a ServeRAID-7t S-ATA controller in PCI slot 3
or slot 4.
To install a SATA hard disk drive in bay 4 or 5, complete the following steps:
1. Read the safety information that begins on page v and the “Installation
guidelines” on page 16.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords.
3. Remove the side cover (see “Removing the side cover” on page 19).
4. Remove the blue thumbscrew that secures the hard disk drive cage to the
chassis and set it aside.
Chapter 2. Installing optional devices
29