IBM System Storage EXP2512 Express Storage Enclosure, Инструкция по установке, использованию и обслуживанию

Страница: 49 / 72

Replacing the bezels
The left bezel contains the LEDs; the right bezel shows the hard disk drive IDs. See
the illustrations in “Front view: components” on page 17
Removing the bezels
Right bezel
Left bezel
Handles
To remove either the left or right bezel, complete the following steps:
1. If the EXP2500 is on a table or other flat surface, elevate the EXP2500 front
slightly or extend the front over the table edge.
2. Grasp the handle on the front of the bezel and pull until the bezel is clear of the
bottom tab on the chassis flange.
3. Lift the bezel off the chassis flange.
Installing the bezels
To install either the left or right bezel, complete the following steps:
1. Fit the cutout that is on the top of the bezel over the tab on the chassis flange.
2. Rotate the bezel down until it snaps into place. Make sure that the inside
surface of the bezel is flush with the chassis.
Chapter 4. Parts listing, EXP2512 and EXP2524 expansion enclosures
37