IBM Storwize V5100 MTM 2078-12F, Быстрое руководство по установке

Страница: 67 / 144

7. Repeat steps “5” on page 41 through “6” on page 41 to install the opposite rail.
8. Install the expansion enclosure in the rack, as described in “Installing an optional 5U SAS expansion
enclosure” on page 49.
Installing or replacing the fascia: 2077-92F, 2077-A9F
During the initial installation process or after you perform service, you can install the fascia components
on the front of a 2077-92F, 2077-A9F expansion enclosure.
About this task
The 4U fascia covers the display panel of the expansion enclosure. It is attached to the enclosure by four
screws. The bottom 1U fascia covers both of the power supply units (PSUs) on the enclosure. As Figure
36 on page 43 shows, the fascias are independent; you can remove or replace one without having to
remove or replace the other.
Figure 36. Fascia components on the expansion enclosure
Note: When the expansion enclosure is shipped, the 4U and 1U fascia are not installed. You must install
them as part of the initial installation process.
Procedure
Attach the front (4U) fascia
1. Align the front 4U fascia with the enclosure so that the thumbscrews go through the holes on each
side. As Figure 37 on page 44 shows, this action aligns the screw holes on the back of the fascia with
the screw holes on the front flange of the enclosure.
2. Replace the four screws to reattach the 4U fascia. Secure the screws from the back of the flange and
into the rear of the fascia. Each side of the 4U fascia contains two screws.
Attach the bottom (1U) fascia
3. Reattach the bottom 1U fascia that covers the power supply units (PSUs). Align the fascia with the
enclosure and gently push it until it clicks into place on the chassis, as shown in Figure 37 on page
44.
Chapter 2. Installing the system hardware 43