IBM SAN Volume Controller 2145-8F2, Руководство по установке оборудования

Страница: 73 / 96

2. Insert the bracket onto the power cable so that the power cable is held by the
slot on the end of the bracket. Figure 45 provides a view of how to align the
cable retention bracket with the cable.
3. Position the cable retention bracket against the support rail and attach the
bracket onto the slot in the rear of the rail. Figure 46 provides a view of the
cable retention bracket that is attached to the SAN Volume Controller 2145-8F4.
Connecting the SAN Volume Controller 2145-8F4 or the SAN Volume
Controller 2145-8F2 to the SAN and to the Ethernet network
Before you connect the SAN Volume Controller 2145-8F4 or the SAN Volume
Controller 2145-8F2 to the SAN, you must connect the Ethernet and fibre-channel
cables.
Before you begin this task, refer to the user’s cable connection table to find out
where to connect the Ethernet and fibre-channel cables.
To connect the SAN Volume Controller 2145-8F4 or the SAN Volume Controller
2145-8F2 to the SAN and to the Ethernet network, perform the following steps:
1. Connect the Ethernet cable to Ethernet port 1
5
in Figure 47 on page 50 or
Figure 48 on page 50.
svc00175
Figure 45. Attaching the cable retention bracket to the SAN Volume Controller 2145-8F4
power cable
svc00174
Figure 46. SAN Volume Controller 2145-8F4 with cable-retention bracket attached
Chapter 4. Installing the SAN Volume Controller 2145-8F4 or the SAN Volume Controller 2145-8F2 hardware
49