IBM REDPAPER 520Q, Технический обзор и введение

Страница: 40 / 110

26
IBM System p5 520 and 520Q Technical Overview and Introduction
2.1 The processor
The IBM processor capitalizes on all the enhancements brought by the POWER5
processor. For a detailed description of the POWER5 processor, refer to IBM System p5 520
Technical Overview and Introduction, REDP-9111. Figure 2-2 shows a high level view of the
processor.
Figure 2-2 processor
The CMOS10S technology in the processor uses a 90 nanometer or nm
fabrication process, which enables:
򐂰 Performance gains through faster clock rates
򐂰 Processor size reduction (243 mm compared with 389 mm)
The processor is 37% smaller than the POWER5 processor. It consumes less
power and requires less cooling. Thus, you can use the processor in servers
where previously you could only use lower frequency processors due to cooling restrictions.
The design provides the following additional enhancements:
򐂰 New page sizes in ERAT and TLB. Two new pages sizes (64 KB and 16 GB), which were
recently added in PowerPC® architecture.
򐂰 New segment size in SLB. One new segment size (1 TB) was recently added in PowerPC
architecture.
򐂰
The TLB size has been doubled in the over the POWER5 processors. The
TLB in has 2048 entries.
򐂰 Floating-point round to integer instructions. New instructions (frfin, frfiz, frfip, frfim) have
been added to round floating-point numbers with the following rounding modes: nearest,
zero, integer plus, and integer minus.
򐂰
Improved floating-point performance.
򐂰 Lock performance enhancement.
򐂰 Enhanced SLB read.
򐂰 True Little-Endian mode. Support for the True Little-Endian mode as defined in the
PowerPC architecture.
Core
2.1 GHz
Core
2.1 GHz
Core
2.1 GHz
Core
2.1 GHz
1.9 MB L2
L3
Intf
Mem
Cntrl
GX+
Intf
SMP
Fabric
Bus
L3
Bus
Mem
Bus
GX+
Bus
Vertical
Fabric
Bus
POWER 5+ Processor
Enhanced Distributed Switch
(Fabric Bus Controller)