IBM RackSwitch G8000, Руководство по установке

Страница: 25 / 86

CAUTION:
This product might contain one or more of the following devices: CD-ROM
drive, DVD-ROM drive, DVD-RAM drive, or laser module, which are Class 1
laser products. Note the following information:
v
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of the controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation exposure.
(C026)
CAUTION:
Data processing environments can contain equipment transmitting on system
links with laser modules that operate at greater than Class 1 power levels. For
this reason, never look into the end of an optical fiber cable or open
receptacle. (C027)
Four 1 Gbps Small Form-factor Pluggable (SFP) slots are located on the front
panel. These slots accept approved optical or copper SFP transceivers.
Transceivers must be purchased separately.
For the available transceivers and direct attach cables (DACs) for the switch, see
https://www-01.ibm.com/products/hardware/configurator/americas/bhui/launchNI.wss.
Console port
The RS-232 (mini-USB) serial console port is located on the front panel. The
following table describes the pinouts for the mini-USB port.
Table 5. Console port pin assignments
Pin number Function
Pin 1 No connect
Pin 2 RS232-SIN
Pin 3 RS232_SOUT
Pin 4 No connect
Pin 5 Ground
The console cable provides an RJ-45 connector (see Table 4 on page 8 for RJ-45
pin assignments). A retention clip is available to secure the console connection.
The following table describes the pin assignments for the RJ-45 connector on the
console cable.
Table 6. Console connector wiring
D9 Pin number Wire Mini-USB
Pin 2 Black Pin 3
Pin 3 White Pin 2
Pin 5 Green Pin 5
Chapter 1. Introduction
9