IBM QS22 - BladeCenter - 0793, Руководство по обслуживанию

Страница: 69 / 158

1. Reinstall the front bezel assembly on the blade server if removed. See
“Installing the front bezel assembly” for further information.
2. Ensure that the I/O buffer DIMM slots are occupied either by DIMMs or by
DIMM fillers. No DIMM fillers are needed for empty system memory DIMM slots.
3. Replace and close the blade server cover, unless you installed an optional
expansion unit that has its own cover. See “Closing the blade server cover” on
page 52 for further information.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
4. Reinstall the blade server into the BladeCenter unit.
5. Turn on the blade server. See “Turning on the blade server” on page 4 for
further information.
6. If you have replaced the battery or the system board assembly, reset the
system date and time through the operating system that you installed. For
additional information, see your operating system documentation.
Note: If you have just powered on the BladeCenter unit, wait until the power on
LED on the blade server flashes slowly before powering on the blade server.
Installing the front bezel assembly
Figure 24 on page 52 shows how to install the front bezel assembly on the blade
server.
Chapter 4. Installing and removing replaceable units
51