6
To install another memory module, repeat steps 1–5.
7
Go to the device-record form in Using Your Personal Computer and record this
installation.
What to do next
To work with another option, go to the appropriate section.
To complete the installation, go to Chapter 7, “Completing the Installation”
on page 66.
Removing a Memory Module
Before you begin
Read “Electrical Safety” on page 3 and “Handling Static-Sensitive Devices”
on page 4.
Read the instructions that come with the optional device.
Turn off the computer and all other connected devices.
Disconnect all cables attached to the computer.
Attention:
The presence of 5 V standby power might result in damage to
your hardware unless you disconnect the power cord from the wall before
opening the computer cover.
Remove the computer cover (see “Disconnecting Cables and Removing the
Cover” on page 5), and lay the computer on its side.
1
To locate the memory connectors inside your computer, see “Identifying Parts
on the System Board” on page 11.
2
At both ends of the memory module connector, push outward on the retaining
clips until the module is loosened. Lift the memory module out of the
connector.
Note:
Be careful not to push too hard on the retaining clips because the
module may abruptly eject from the connector.
Chapter 3. Working with Options on the System Board
15
