IBM p5 550, Технический обзор и введение

Страница: 64 / 110

50
IBM System p5 550 and 550Q Technical Overview and Introduction
Virtual SCSI
The POWER Hypervisor provides a virtual SCSI mechanism for virtualization of storage
devices (a special logical partition to install the Virtual I/O Server is required to utilize this
feature; see 2.12.3, “Virtual I/O Server” on page 54). The storage virtualization is
accomplished using two, paired, adapters: a virtual SCSI server adapter and a virtual SCSI
client adapter. Only the Virtual I/O Server partition can define virtual SCSI server adapters;
other partitions are
client
partitions. The Virtual I/O Server is available with the optional
Advanced POWER Virtualization feature (FC 7941).
Virtual Ethernet
The POWER Hypervisor provides a virtual Ethernet switch function that allows partitions on
the same server to use a fast and secure communication without any need for physical
interconnection. The virtual Ethernet allows a transmission speed in the range of 1 to 3 GBps.
depending on the MTU
2
size and CPU entitlement. Virtual Ethernet requires a system with
either AIX 5L Version 5.3 or the appropriate level of Linux supporting virtual Ethernet devices
(see 2.14, “Operating system support” on page 63). The virtual Ethernet is part of the base
system configuration.
Virtual Ethernet has the following major features:
򐂰 The virtual Ethernet adapters can be used for both IPv4 and IPv6 communication and can
transmit packets with a size up to 65408 bytes. Therefore, the maximum MTU for the
corresponding interface can be up to 65394 (65390 if VLAN tagging is used).
򐂰
The POWER Hypervisor presents itself to partitions as a virtual 802.1Q compliant switch.
The maximum number of VLANs is 4096. Virtual Ethernet adapters can be configured as
either untagged or tagged (following the IEEE 802.1Q VLAN standard).
򐂰 A partition supports 256 virtual Ethernet adapters. Besides a default port VLAN ID, the
number of additional VLAN ID values that can be assigned per Virtual Ethernet adapter is
20, which implies that each Virtual Ethernet adapter can be used to access 21 virtual
networks.
򐂰 Each partition operating system detects the virtual local area network (VLAN) switch as an
Ethernet adapter without the physical link properties and asynchronous data transmit
operations.
Any virtual Ethernet can also have a connection outside of the box if a layer-2 bridging to a
physical Ethernet adapter is set in one Virtual I/O server partition (see 2.12.3, “Virtual I/O
Server” on page 54 for more details about shared Ethernet).
Virtual (TTY) console
Each partition needs to have access to a system console. Tasks such as operating system
installation, network setup, and some problem analysis activities require a dedicated system
console. The POWER Hypervisor provides the virtual console using a virtual TTY or serial
adapter and a set of Hypervisor calls to operate on them. Virtual TTY does not require the
purchase of any additional features or software, such as the Advanced POWER Virtualization
feature.
2
Maximum transmission unit
Note: Virtual Ethernet is based on the IEEE 802.1Q VLAN standard. No physical I/O
adapter is required when creating a VLAN connection between partitions, and no access to
an outside network is required.