IBM NetVista 6029, Руководство по техническому обслуживанию аппаратной части

Страница: 96 / 136

2. Insert the flash update diskette into drive A.
3.
Power-on the computer.
4. When the Update Utility appears; select the country/keyboard, then press
Enter .
5. If the computer serial number was previously recorded, the number is
displayed with an option to update it. Press
Y to update the serial number.
6. Type the 7-digit serial number of the computer you are servicing, then press
Enter .
7. Follow the instructions on the screen to complete the flash (BIOS/VPD) update
procedure.
Flash recovery boot block jumper
Attention:
If an interruption occurs during a Flash/BIOS upgrade, the BIOS might be left in an
unusable state. The Boot Block jumper enables you to restart the system and recover the
BIOS.
To perform a Flash/BIOS recovery using the recovery jumper, use the following
procedure.
1. Power-off the computer and remove the cover.
2.
Move the system board Virtual clear CMOS/BIOS recovery jumper to the
ROM
recovery
position. Refer to “Identifying parts on the system board” on page 24
or the label inside the computer for more information.
3. Insert the upgrade diskette into the diskette drive.
4. Power-on the computer. The IBM Logo will appear.
5. When the Flash Update Utility appears, select the country/keyboard, then press
Enter .
6. If the computer serial number was previously recorded, the number is
displayed with an option to update it. Press
Y to update the serial number.
7. Type the 7-digit serial number of the computer you are servicing, then press
Enter
.
8. Follow the instructions on the screen to complete the flash (BIOS/VPD) update
procedure.
9.
When you are instructed to reboot the computer, power-off the computer and
move the recovery jumper to the
normal position. Then replace the cover and
power-on the computer.
90
Hardware Maintenance Manual