IBM Netfinity 5Ux24D Tower-to-Rack Kit, Руководство по установке

Страница: 20 / 38

24. Install the left and right release-latch-bracket assemblies on the server as shown below:
C
B
A
Figure 15. Installing the release-latch-bracket assemblies
a. Insert the bracket tab
B
into the slot on the side of the server
A
until the upper notch on the
bracket tab aligns with the side of the server.
Note: The left bracket is marked with an L .
b. Push the bracket up until the holes in the bracket align with the holes in the side of the server;
then, secure the bracket with two M3.5 screws.
c. Use the above steps to install the right-side release-latch-bracket assembly.
25. To install the new bezel that comes with this kit, align the tabs on the back of the bezel with the tab
openings on the front of the server; then, swing the bezel toward the server and press until it snaps
into place.
Figure 16. Installing the new bezel
12
5Ux24D Tower-to-Rack Kit Installation Instructions