IBM N7800, Руководство по аппаратуре и обслуживанию

Страница: 156 / 182

4. Slide the module in as far as it can go, and push on the edges of the module to
make sure that it is properly seated.
5.
Tighten the thumbscrews on the module to secure it to the chassis.
6. Reinstall the bezel.
7. Reconnect the power cords, turn on the power and boot the system.
Attention: If your system is in an HA pair, you must enable it again. Use the
cf giveback command (in 7-Mode) or the storage failover giveback
command (in Cluster-Mode) from the partner node's console to reenable your
HA pair. A successful giveback ends with a message on the partner node
indicating successful giveback.
Note:
If
Waiting for Giveback
is not displayed prior to giveback, reboot the
controller module. If this continues, contact technical support.
Completing the replacement process
Return the failed part to IBM. Contact IBM Service and Support at 1-800-IBM-SERV
(1-800-426-7378) for more information on the return procedure.
Installing the Cable Management Tray on an N7000 series system
You must use this procedure to install the cable management tray.
Procedure
1. Align the edges of the cable management tray with the slots on the back of the
system.
1
Cable management tray
2. Slightly tilt the cable management tray up and push it into the slots on the
back of the system. You might need to pinch the edges of the cable
management tray to insert it into the slots.
3.
Lower the tray into place and make sure it is seated properly. Repeat the
preceding steps if it is not seated.
4. Cable your system as needed.
1
Figure 35. Installing the cable management tray
130
IBM System Storage: N7000 Series Hardware and Service Guide