IBM IntelliStation E Pro 6836, Руководство пользователя

Страница: 119 / 156

Clearing CMOS
If you need to erase configuration information, you must move the CMOS jumper.
See the illustration in “Recovering BIOS” on page 99 for the location of the CMOS
jumper.
The default position is a jumper installed on pins 1 and 2. Before you change the
position of this jumper, you
must turn off the computer and attached devices, and
disconnect all external cables and power cords. Remove the cover and then move
the jumper to pins 2 and 3.
Note: If possible, record your computer configuration information before moving
the CMOS jumper.
After moving the jumper, wait at least 5 minutes for the CMOS information to
clear.
Changing the position of this jumper erases all configuration and setup
information, including the power-on and administrator passwords. Therefore, you
must reconfigure the computer after clearing CMOS memory (see “Chapter 4.
Configuring your computer” on page 27).
After you clear the CMOS information, move the jumper back to its normal
position (pins 1 and 2). Reconnect the external cables and power cords; then, turn
on the attached devices and the computer.
Replacing the battery
When replacing the battery, you must replace it with a lithium battery of the same
type from the same manufacturer. To avoid possible danger, read and follow the
safety statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call
your IBM reseller or IBM marketing representative.
Note:
After you replace the battery, you must reconfigure your system and reset
the system date and time.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent
type battery recommended by the manufacturer. If your system has a module containing
a lithium battery, replace it only with the same module type made by the same
manufacturer. The battery contains lithium and can explode if not properly used,
handled, or disposed of.
Do not:
v
Throw or immerse into water.
v
Heat to more than 100 C (212 F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Chapter 6. Solving problems
103