IBM IntelliStation A Pro, Руководство по установке

Страница: 49 / 106

139
4
Air baffle
Power supply alignment flange
Locking
lip
a. Orient the air baffle as shown and align it with the side of the power supply.
b. Insert the small end of the baffle into the computer toward the front of the
computer.
c. Lower the larger end of the baffle until the side flange rests on the power
supply.
d. Slide the baffle toward the rear of the computer until it stops and the rear
flange (locking lip) is inside the computer chassis; then, press down on the
large end of the baffle until it clicks into place.
18. If you have other options to install or remove, do so now. Otherwise, replace
the support bracket (see “Removing and installing the support bracket” on
page 16); then, go to “Completing the installation” on page 39.
Installing a security rope clip
To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
v
A flat-blade screwdriver
v
An adjustable wrench
v
A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing
number 3230, stock number 176-735)
v Threaded nuts that fit the rope clip
v
A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all external cables and power cords; then, remove the side cover
(see “Removing the cover” on page 15).
Chapter 2. Installing the hardware
37