IBM FlashSystem 5000 Series, Быстрое руководство по установке

Страница: 65 / 106

Procedure
1. Carefully lower the cover and ensure that it is aligned correctly with the back of the enclosure, as
shown in Figure 35 on page 47.
Figure 35. Aligning the top cover
2. Push the cover release lever to the side ( 2 ) as shown in Figure 36 on page 47.
3. Slide the cover towards the back of the enclosure ( 3 ) back until it stops, as shown in Figure 36 on
page 47.
Figure 36. Replacing the top cover
4. Verify that the cover correctly engages the cover release latch and all of the inset tabs on the
expansion enclosure.
5. Lock the cover into position by sliding the release lever 4 , as shown in Figure 37 on page 47
Figure 37. Locking the top cover
Installing or replacing a 5U expansion enclosure in a rack
Use the following procedure to place a 5U expansion enclosure in a rack during the installation process.
To complete some service tasks, you might also need to slide the enclosure back in to the rack.
About this task
Important: The 5U expansion enclosure is heavy. Before you install the expansion enclosure in the rack
for the first time or replace it in the rack to complete a service task, review and implement the following
tasks:
• Always use a suitably rated mechanical lift or four persons to raise the enclosure to install it in the rack.
Even after the drives, power supply units, secondary expander modules, canisters, fans, and top cover
are removed, the enclosure weighs 43 kg (95 lbs).
• Install the expansion enclosure in the lowest position in the rack. Figure 38 on page 48 shows an
example.
Chapter 4. Installing the system hardware 47