IBM FlashSystem 5000 Series, Быстрое руководство по установке

Страница: 32 / 106

– The product might be equipped with multiple power cords. To remove all hazardous voltages,
disconnect all power cords.
– Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the
outlet supplies proper voltage and phase rotation according to the system rating plate.
– Connect any equipment that will be attached to this product to properly wired outlets.
– When possible, use one hand only to connect or disconnect signal cables.
– Never turn on any equipment when there is evidence of fire, water, or structural damage.
– Disconnect the attached power cords, telecommunications systems, networks, and modems
before you open the device covers, unless instructed otherwise in the installation and
configuration procedures.
– Connect and disconnect cables as described in the following procedures when installing,
moving, or opening covers on this product or attached devices.
To disconnect:
1. Turn off everything (unless instructed otherwise).
2. Remove the power cords from the outlets.
3. Remove the signal cables from the connectors.
4. Remove all cables from the devices.
To connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. Attach the power cords to the outlets.
5. Turn on the devices.
– Sharp edges, corners and joints might be present in and around the system. Use care when
handling equipment to avoid cuts, scrapes and pinching. (D005)
Tools needed
A flat-blade screwdriver with a 7 mm (1/4 inch) head is required to complete the installation.
Reviewing your packing slip
After you open your shipment, you must verify the contents against the packing slip.
In each box, locate the packing slip. Verify that the items that are listed in the packing slip match what is
in the box, and that any optional items that you ordered are included in the list. Your shipment might
contain extra items, depending on the order.
Note: If you purchased your equipment through a reseller, some of the options might be preinstalled.
Contact your supplier for details.
Use the following checklist to check off the items in your order as you verify that they are included in your
shipment.
__ • Rack-mounting hardware kit:
__ – Two rails (right and left assembly)
__ – Two rail springs
__ – Two sets of rail-mount screws and alternative rail-mount pins (large and small) for non-IBM
racks
__ • Two power cords for connection to rack-mounted power distribution units
__ • Drive bay blanking plates (installed in the enclosure)
14 IBM FlashSystem 5000 : FlashSystem 5000 Quick Installation Guide