IBM eServer xSeries 135, Руководство пользователя

Страница: 76 / 144

64
IBM xSeries 135: User’s Reference
4. In IBMSet, click Join VLAN. Note that VLANs cannot be assigned to adapters
that are already defined to have an adapter teaming option.
5. Type the VLAN ID and VLAN name. The VLAN ID must match the VLAN ID of
the switch. The ID range is from 1 to 1000. The VLAN name is for information
only and does not need to match the name on the switch.
6. Click Join VLAN. Repeat steps 3 through 5 for each VLAN that you want the
server to join. The VLANs that you add are listed on the Adapters tab.
7. Click Close, and restart the computer.
Ethernet port connector
The following table shows the pin-number assignments for the RJ-45 connector. These
assignments apply to both 10BASE-T and 100BASE-TX devices.
Working with cables
The following sections discuss how to cable your appliance server to an existing
network. For an illustration of the rear connectors of the appliance server, see “I/O
connector locations and ports” on page 57.
Connecting the IBM xSeries 135 appliance server to the
network
The IBM xSeries appliance server has two Ethernet connectors that you can use to
integrate the appliance server to an existing local area network (LAN). You can use
one or both Ethernet ports, but some software features can function properly only if
the server is connected to the LAN through Ethernet port 1.
Connect Category 5 Ethernet cable to the server Ethernet ports to install the server in
an existing network.
Cable management
Use the cable ties and hook-and-loop straps that are supplied with your server to
secure the cables.
Attention:
Do not secure cables too tightly. Overtightening can cause internal damage
to cables
Table 10. Ethernet RJ-45 connector pin-number assignments.
Pin Signal Pin Signal
1 Transmit data+ 5 Not connected
2 Transmit data- 6 Receive data -
3 Receive data+ 7 Not connected
4 Not connected 8 Not connected