IBM eServer xSeries 135, Руководство пользователя

Страница: 66 / 144

54
IBM xSeries 135: User’s Reference
8. Install the heat sink on the microprocessor:
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure
that the square of thermal material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor.
Note: Locate the slot in the channel of the heat sink. Orient the heat sink so
that the slot will be at the rear of the server.
c. Align and place the clip over the heat sink; then, snap the clip into place over
the heat sink with the heat-sink release lever in the up position.
Note: If you remove the microprocessor later, remember to install the
terminator card in the appropriate microprocessor connector.
d. Press the heat sink release lever down into the locked position when the clip
is in place.
9. Replace the clear shield.
Note: If you need to replace an existing microprocessor, call for service.
10. Replace the cover on the server; then, reinstall the server in the rack and connect
all external cables. For more information, see “Installing the cover” on page 56 for
instructions.
11. Start the server and run the Configuration/Setup Utility program.
Clip
Heat sink
Microprocessor
Terminator card
Heat sink release
lever Slot
Top view of
heat sink