IBM eServer BladeCenter HS20 Type 8832, Руководство по диагностике и обслуживанию

Страница: 36 / 112

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Type 7981 and 1884,” on page 53 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
164 Memory configuration changed.
1. Run the Configuration/Setup Utility program,
verify the memory configuration is correct and
save the settings.
2. Reseat the DIMMs.
3. Replace the following components one at a time,
in the order shown, restarting the blade server
each time:
a. DIMMs
b. (Trained service technician only) System
board assembly
175 Bad EEPROM CRC #1 (Trained service technician only) Replace the system
board assembly.
177 Bad checksum (Trained service technician only) Replace the system
board assembly.
178 EEPROM not functional (Trained service technician only) Replace the system
board assembly.
184 Power-on password damaged.
1. Run the Configuration/Setup Utility program,
select Load Default Settings , and save the
settings.
2. (Trained service technician only) Replace the
system board assembly.
185 Corrupted boot sequence
1. Run the Configuration/Setup Utility program,
select Load Default Settings , and save the
settings.
2. (Trained service technician only) Replace the
system board assembly.
186 Security hardware control logic error (Trained service technician only) Replace the system
board assembly.
187 VPD Serial Number not set
1. Run the Configuration/Setup Utility program,
select Load Default Settings , and save the
settings.
2. (Trained service technician only) Replace the
system board assembly.
188 Bad EEPROM CRC #2 (Trained service technician only) Replace the system
board assembly.
189 An attempt was made to access the blade
server with invalid passwords.
Restart the blade server, run the Configuration/Setup
Utility program, and change the power-on password.
198 Processor speed mismatch detected. The
two installed microprocessors are not the
same frequency.
Replace one of the microprocessors with a
microprocessor of the same type and speed as the
remaining installed microprocessor.
20
BladeCenter HS20 Type 7981 and 1884: Problem Determination and Service Guide