IBM eServer 445 xSeries, Руководство по установке

Страница: 40 / 124

3. See the documentation that comes with your adapter for any cabling
instructions.
Note: Route adapter cables before you install the adapter.
4. Set any jumpers or switches as described by the adapter manufacturer.
Note: Do not install an adapter in PCI-X slot 1 if you are going to install the
serial port that comes with your server. See “Installing the serial port” on
page 31 for instructions for installing the serial port.
5. Install the adapter:
a. Open the blue adapter guide by lifting the front edge, as shown in the
illustration.
b. Push the orange adapter retention latch toward the rear of the server and
open the tab.
c. Remove the expansion-slot cover and the PCI-X divider.
d. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the PCI-X board.
e. If necessary, remove the extension handles or bracket before installing a
long adapter.
Attention: When you install an adapter, be sure the adapter is correctly
seated in the connector. Improperly seated adapters might cause damage to
the PCI-X board or to the adapter.
NO
TE
:
FO
R P
RO
PE
R A
IRF
LO
W,
RE
PL
AC
E F
AN
W
ITH
IN 2
M
INU
TE
S
FR
ON
T O
F B
OX
NO
TE
:
FO
R P
RO
PE
R A
IRF
LO
W,
RE
PL
AC
E F
AN
W
ITH
IN 2
M
INU
TE
S
FR
ON
T O
F B
OX
Tab
Adapter
retention
latch
Attention
LED
Power
LED
Adapter guide
PCI-X
divider
Figure 24. PCI-X slot components
28
xSeries 445 Type 8870: Installation Guide