IBM DS3950, Инструкция по установке, использованию и обслуживанию, Страница: 125 / 252

about LED status for storage expansion enclosures, see “Checking the
LEDs” on page 102 or the Installation, User’s, and Maintenance Guide for
your storage expansion enclosure.
b.
Check all LEDs on each component in the storage subsystem. Make sure
that all the LEDs show normal status. For information about LED status, see
“Solving problems” on page 155.
c. Open the DS Storage Manager Subsystem Management window, and
display the Physical View for the configuration.
The status for each component will be either Optimal or Needs Attention.
d. Review the status of the configuration components shown in the Subsystem
Management window by selecting the applicable component button for
each storage subsystem.
8. Are the LEDs indicating normal operation, and is the status Optimal on all the
configuration components?
v
Yes — End of procedure.
v
No — Go to step 9.
9. Diagnose and correct the fault by completing the following steps.
a. Run the DS Storage Manager Recovery Guru by selecting the Recovery
Guru toolbar button in the Subsystem Management window.
b. Complete the recovery procedure.
If the Recovery Guru directs you to replace a failed component, use the
individual LEDs on the storage subsystem to locate the specific failed
component. For troubleshooting procedures, see Chapter 6, “Hardware
maintenance,” on page 155.
c. When the recovery procedure is completed, select Recheck in the Recovery
Guru. This action reruns the Recovery Guru to make sure that the problem
has been corrected.
d. If the problem persists, contact your IBM service representative.
Installing the DS Storage Manager client
Depending on the controller firmware version for your subsystem, refer to the
following guides for instructions to install the DS Storage Manager software:
v
IBM System Storage DS Storage Manager Version 10 Installation and Host Support
Guide
(for storage subsystems with controller firmware version earlier than
7.8x.xx.xx)
v
IBM System Storage DS Storage Manager Version 10.8 Installation and Host Support
Guide
(for storage subsystems with controller firmware version 7.8x.xx.xx or
later)
Use that document and the online help to configure the logical drives, partitions,
and so on for the RAID controllers. Use your operating system documentation to
make the new logical drives accessible to the operating system.
Note: Do not proceed with the configuration setup until you have completed the
DS Storage Manager installation.
Assemble any additional items in preparation for software installation. These items
might include the following:
v
HBA drivers
v
Controller firmware version listed at the IBM System Storage Support Web site:
Chapter 4. Operating the storage subsystem
97
1|
1|
1|
1|
1|
1|
1|
1|