IBM Deskstar 40GV, Инструкция по установке и справочник

Страница: 10 / 66

6
3. Leave the jumpers as set. The jumpers are factory set to Master, 16 heads.
Note: The IBM Deskstar has an option jumper block located next to the interface connector. Setting these
jumpers allows you to use the different options of the hard disk drive. See the “Jumpers” section of the
Appendix for jumper setting descriptions.
Attach the cables
Note: With some system chassis, it may be more convenient to attach the cable after the drive is mounted.
The order of the steps below may change depending upon your system.
Note: The 40-pin, 80-conductor ATA/IDE cable provided with the IBM Deskstar is color-coded for the
master, slave, and system connectors. The Master connector is black, the Slave connector is gray, and the
system connector is blue.
1. To use the provided ATA/IDE cable, remove the existing cable from the primary ATA/IDE
connector of your motherboard or controller card.
2. Attach the blue connector of the ATA/IDE cable to the ATA/IDE connector marked “Primary” or
“0” on the motherboard or controller card. The primary ATA/IDE connector controls the first and
second ATA/IDE devices in the system.