IBM D3Q1KMST, Руководство пользователя

Страница: 6 / 30

Before you begin installing a graphic accelerator adapter, ensure that
your display driver is set to standard VGA mode (640 x 480) by
following the table below.
Installing an AGP/PCI Digital TFT
2D/3D P&D A/D G200 Graphics
Accelerator Adapter
To install an AGP/PCI Digital TFT 2D/3D P&D A/D G200 Graphics
Accelerator Adapter:
1. Turn off your computer and all peripherals such as your monitor
or printer and open your computer.
2. A graphics adapter is often built into your computer's
motherboard so you do not need to remove any hardware.
However, if there is a graphics adapter card in a separate
expansion slot, you should remove it.
Note: Inserting a graphic accelerator adapter into the wrong type
of slot could damage your card, your computer, or both.
3. Most computers have different types of expansion slots. Choose
an AGP or PCI slot, depending on the type of graphic accelerator
adapter you have. Your system manual should identify the
location of each type of expansion slot in your computer.
If you have an AGP card, do not insert the plastic tab next to the
connector pins into the slot.
4. Remove the cover for the slot you intend to use. Save the screw
for the mounting bracket. Position your graphic accelerator
adapter over the expansion slot you have chosen. Push the card
in firmly and evenly until it is fully seated in the slot. Replace
Operating System Procedure
Windows 95/98 No actions required.
Windows NT 4.0 1. Click Start, Settings, and
then Control Panel.
2. Double-click the Display
icon.
3. Click the Settings tab.
4. In the Desktop Area move
the marker to 640 x 480.
5. Click OK
1-2 User's Guide Supplement