IBM D3Q1KMST, Руководство пользователя

Страница: 7 / 30

the screw to secure the bracket of your graphic accelerator
adapter to the computer frame.
This adapter comes with the bracket for the ATX-type computer
installed. To install the bracket in an NLX-type computer, follow
the diagram below.
5. Plug one end of the monitor cable into the monitor connector on
an AGP/PCI Digital TFT 2D/3D P&D A/D G200 Graphics
Accelerator Adapter. Plug the other end of the monitor cable into
your monitor.
Refer to the your monitor’s installation guide to make sure that
the monitor is properly set up.
For IBM systems, refer to About Installing Options for instructions on
opening the computer cover, removing existing adapter cards, and
installing adapter cards in expansion slots.
Installing the software
This section has instructions for installing the software and device
drivers for an AGP/PCI Digital TFT 2D/3D P&D A/D G200 Graphics
Accelerator Adapter. Instructions are for installing the software with
either Windows 95/98 or Windows NT 4.0.
1. Start your computer.
Windows 95/98 will automatically detect your new hardware and
will start the New Hardware Wizard. If appropriate display
drivers have not been previously installed, Windows 95 reports
finding a PCI adapter (even if you have an AGP card).
If the New Hardware Found dialog box is displayed, click
Do not install a driver, then click OK.
If the Update Device Driver Wizard dialog box is
displayed, click Next, then click Finish.
If the Add New Hardware Wizard dialog box is displayed,
click Next four times, then click Finish, and then click Yes
to restart your computer.
Part 1: Installation Guide 1-3