IBM CN4093, Руководство пользователя

Страница: 39 / 62

Where yyyy is the boot image file name.
4. Reset and restart the switch as described in “Resetting and restarting the
switch.”
Resetting and restarting the switch
To activate the new image or images, you must reset the switch. To reset the
switch, complete the following steps.
1. Log on to the IBM Flex System Chassis Management Module (CMM) CLI as
described in the switch's User's Guide or CLI Reference Guide for the CMM. If
necessary, obtain the IP address of the management module from your system
administrator.
2. Set the environment to the bay where you installed the switch. For example:
system> env -T system:switch[1]
3. Type the
reset
command to restart the switch. Wait approximately 100 seconds
for POST to complete.
system:mm[1]> env -T system:switch[1]
system:switch[1]> reset
4. Type the info command for the switch that was just restarted and note the
corresponding level of the firmware for the switch. Confirm that the firmware
build number reflects the correct firmware release. For example:
system:switch[2]> info
...
Boot ROM
Rel date: 04/02/2013
Version: 7.7.1.12
Status: Active
Main application
Rel date: 04/02/2013
Version: 7.7.1.12
Status: Active
Main application
Rel date: 03/22/2013
Version: 7.7.1.12
Status: Inactive
Acquiring feature licenses
The base option supports twenty-two total data ports (fourteen compute node ports
and eight uplink ports). Upgrade licenses are available that enable the use of
additional ports on the switch:
v
Upgrade 1 - This upgrade feature adds an additional fourteen compute node
ports and two 40 Gb uplink ports (also usable in four 10 Gb mode) to the base
product.
v
Upgrade 2 - This upgrade feature adds an additional fourteen compute node
ports and six uplink ports to the base product.
Note: Upgrade 1 and Upgrade 2 are independent and can be installed in any
order, with or without the other.
Upgrade licenses are unique to each switch and are non transferable.
Chapter 4. Updating the firmware and licensing
29