IBM CN4093, Руководство пользователя

Страница: 20 / 62

13. Attach any cables that are required by the switch. For additional information
about cabling the switch, see “Cabling the switch and the SFP+ and QSFP+
modules” on page 14, the documentation that comes with the cables. For the
locations of the connectors on the IBM Flex System chassis, see the
documentation that comes with the IBM Flex System chassis. Then, continue
with the next step.
14. Make sure that the external ports on the switch are enabled through one of the
Chassis Management Module (CMM) interfaces, such as, the Web-based
interface or the CLI.
Removing or replacing the switch
Note: The following illustration shows how to remove and replace a switch from a
IBM Flex System chassis. The appearance of your IBM Flex System chassis
might be different; see the documentation for your IBM Flex System chassis
for additional information.
To replace the switch, complete the following steps.
1. Read the safety information that begins on page v, and “Installation guidelines”
on page 7.
2. Disconnect any cables from the switch before you remove the switch.
Disconnecting these cables disrupts the network connection from the external
port to any connected external devices. If you plan to replace the switch with
another switch, you can use the existing cable, provided that it remains securely
attached to the network. For additional information about cabling the switch, see
“Cabling the switch and the SFP+ and QSFP+ modules” on page 14, the
documentation that comes with the cables, and the optional network devices to
which the cables have been connected.
3. Pull the release latches out from the switch. The switch moves out of the bay
approximately 0.6 cm (0.25 inch).
4. Slide the switch out of the bay and set it aside in a static-free location.
5. Place either another switch or a filler module in the bay.
Important : Complete this step within 1 minute. (For more information, see steps
9 and 10 on page 9.)
6. If you placed a switch in the bay, reconnect the other cables that you
disconnected. Attach any additional cables that are required by the switch. For
additional information about cabling the switch, see “Cabling the switch and the
10
CN4093 10 Gb Converged Scalable Switch: User's Guide