IBM BladeCenter QS21 Type 0792, Руководство по обслуживанию

Страница: 90 / 144

If the firmware encounters an error during the startup process, a message
describing the error together with an error code is displayed on the serial console.
There are two types of error, where xxx represents the number of the error code:
Cxxx This is an internal checkpoint. If the system stops during the startup
process a checkpoint may be displayed.
Exxx This type of error means that there is a failure that does not allow
the firmware to continue the startup process. Check the error codes
in the section “Boot errors and handling” on page 72. If these do
not help resolve the problem, contact a service support
representative.
There are cases where a message that is informational only is displayed on the
serial console.
Wxxx This is a warning message. The firmware allows the startup process
to continue, but indicates there maybe a problem. A warning
message can be combined with an error message to give more
complete information about an error.
A complete list of possible messages is given in the section “Boot errors and
handling” on page 72.
Boot errors and handling
The following sections describe boot errors and actions you can take to resolve
these errors.
Boot list
The following table describes boot list errors.
Table 9. System firmware boot list errors
Code Message Description Action
E3400 It was not possible to boot from
any device specified in the VPD
The firmware found a valid VPD
but was not able to find bootable
code on any of the devices listed
in it.
Use Advanced Management
Module Web browser to specify at
least one device that contains
bootable code.
From the Advanced Management
Module Web interface, choose
BladeTasks>Configuration>Boot
Sequence .
E3401 Aborting boot, < details > Boot aborted due to error detected
by the low level code. The
< details > string provides the error
description.
Based on the < details > string you
may have to take an action on
faulty hardware or use the
Advanced Management Module to
correct the system configuration.
If the problem persists, contact
your IBM service representative.
E3402 Aborting boot, internal error. Boot aborted due to error detected
by the low level code.
The exact reason is unknown but
could be a firmware problem.
If the problem persists, contact
your IBM service representative.
72
BladeCenter QS21 Type 0792: Problem Determination and Service Guide