IBM BladeCenter PS703, Руководство по обслуживанию, Страница: 77 / 298

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v
See Chapter 3, “Parts listing, type 7891,” on page 225 to determine which components are CRUs and which
components are FRUs.
Error code Description Action
BA010003 Cannot get server hardware address Perform the following actions that checkpoint
CA00E174 describes:
1. Verify that:
v
The bootp server is correctly configured;
then, retry the operation.
v
The network connections are correct;
then, retry the operation.
2. If the problem persists:
a. Go to “Checkout procedure” on page
176.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 264.
BA010004 Bootp failed Perform the following actions that checkpoint
CA00E174 describes:
1.
Verify that:
v
The bootp server is correctly configured;
then, retry the operation.
v
The network connections are correct;
then, retry the operation.
2. If the problem persists:
a. Go to “Checkout procedure” on page
176.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 264.
BA010005 File transmission (TFTP) failed Perform the following actions that checkpoint
CA00E174 describes:
1. Verify that:
v
The bootp server is correctly configured;
then, retry the operation.
v
The network connections are correct;
then, retry the operation.
2. If the problem persists:
a. Go to “Checkout procedure” on page
176.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 264.
BA010006 The boot image is too large Start up from another device with a bootable
image.
Chapter 2. Diagnostics
65