IBM @Server pSeries 630 6C4, Руководство по установке

Страница: 91 / 180

Configure a Defined Device
Allows a new PCI adapter to be configured into the system if software support is
already available for the adapter. The selected PCI slot will go into the On state.
Install/Configure Devices Added After IPL
The system attempts to configure any new devices and tries to find and install any
required software from a user-selected source.
The add, remove, and replace functions return information to the user indicating
whether the operation was successful. If additional instructions are provided on the
screen, complete the recommended actions. If the instructions do not resolve the
problem, do the following:
v
If the adapter is listed as Unknown, perform the Install/Configure Devices Added
After IPL option to configure the adapter.
v
If you receive a warning indicating that needed device packages are not installed, the
system administrator must install the specified packages before you can configure or
diagnose the adapter.
v
If you receive a failure message indicating a hardware error, the problem might be
either the adapter or the PCI slot. Isolate the problem by retrying the operation in a
different PCI slot, or trying a different adapter in the slot. If you determine that you
have failing hardware, call your service representative.
v
Do not use Install/Configure Devices Added After IPL if your system is setup to
run HACMP clustering. Consult with your system administrator, or software support
for the correct method to configure the replacement device.
Non-Hot-Pluggable PCI Adapter Removal
To remove a PCI adapter, do the following in the order listed:
1. On a Model 6C4, open the front and rear rack doors and put the system into the
service position as described in “Placing the Model 6C4 into the Service Position”
on page 53.
On a Model 6E4, open the bezel door.
2. Shut down the system as described in “Stopping the System” on page 52.
3. Remove the service access cover as described in “Service Access Cover Removal
(Model 6C4)” on page 55 or “Service Access Cover Removal (Model 6E4)” on
page 57. See the following illustration.
4. Determine which adapters you plan to remove, then label and disconnect all
cables attached to that adapter.
5. Record the slot number and location of each adapter being removed.
Note: Adapter slots are numbered on the rear of the system unit.
Chapter 4. Installing Options
75