IBM Aptiva 2190, Техническое обслуживание оборудования, Страница: 82 / 165

2-18
Table 2-3 Error Symptoms List
Error Symptoms Action/FRU
NOTE: To diagnose a problem, first find the error symptom in the left
column. If directed to a check procedure, replace the FRU indicated in the
check procedure. If no check procedure is indicated, the first Action/FRU
listed in right column is the most likely cause.
Hard disk drive LED fails to
light, but system operates
normally.
With the system power on, measure the
voltage of hard disk LED connector J109(See
“Aptiva Type 2190 System Board Layout” on
page 5-3). Its reading should be:
J109 Hard Disk Drive Idle/Active
pin-1
0 Vdc / 0 Vdc
pin-2 +5 Vdc / +5 Vdc
Hard drive LED cable.
CD-ROM Drive
NOTE: Make sure CD-ROM drive is configured correctly in BIOS Setup,
cable/jumper are set correctly and its laser beam is clean before diagnosing
any CD-ROM drive problems.
CD-ROM drive LED flashes for
more than 30 seconds
before LED shutting off.
Software asks to reinstall disc.
Software displays a reading
CD error.
CD may have dirt or foreign material on it.
Check with a known good disc.
CD is not inserted properly.
CD is damaged.
CD-ROM drive LED doesn’t
come on but works normally.
CD-ROM drive
CD-ROM drive cannot load or
eject when the system is
turned on and its eject
button is pressed and held.
CD-ROM drive power.
"CD-ROM Drive" on page 2-30.
CD-ROM drive
CD-ROM drive does not read
and there are no error codes
or messages are displayed.
CD may have dirt or foreign material on it.
Check with a known good disc.
Make sure that the CD-ROM driver is
installed properly.
CD-ROM drive.