IBM 8676 - Eserver xSeries 335, Руководство по техническому обслуживанию и ремонту, Страница: 55 / 172

Working with adapters
This section describes how to install an adapter in the server. Before you continue
with the adapter-installation procedures, review “Adapter considerations.”
Adapter considerations
v Read the documentation that comes with your operating system.
v
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this chapter. If you need to change
switch settings or jumper settings on the adapter, follow the instructions that
come with the adapter.
v The server comes with two 64-bit 100 MHz peripheral component
interconnect-extended (PCI-X) adapter expansion slots on the system board. The
server is designed specifically for PCI-X adapter support, but it also supports PCI
adapters.
v
The expansion slots support both 32-bit and 64-bit adapters. You can install
half-length adapters in slot 1. You can install full-length adapters in slot 2.
v
The server supports 3.3 V and universal PCI and PCI-X adapters; it does not
support 5.0 V-only adapters.
v PCI-X slot 2 and the integrated SCSI controller are on PCI-X bus A (bus 0). The
integrated Ethernet controllers are on PCI-X bus B (bus 1). The integrated video
controller is on PCI bus C (bus 2). PCI-X slot 1 is switchable between PCI-X bus
B and PCI bus C.
Note: If no jumper is installed on jumper block J12, the server determines
automatically the optimal bus to which to attach PCI-X slot 1. If you install
a jumper between pins 1 and 2 on J12, PCI-X slot 1 is forced to PCI bus
C. If you install the jumper between pins 2 and 3 on J12, PCI-X slot 1 is
forced to PCI-X bus B.
If you force slot 1 to bus B and you install an adapter that runs at less
than 100 MHz in the slot, the integrated Ethernet controllers are forced to
run at the slower speed.
If the PCI/PCI-X LED on the system board (CR1; see “System-board
LEDs” on page 42) is on, the slot is operating on bus B; if the LED is not
lit, the slot is operating on bus C.
v The server scans PCI-X slots 1 and 2 to assign system resources. By default,
the server starts (boots) devices in the following order: system IDE and SCSI
devices; then, PCI and PCI-X devices.
Note: To change the boot precedence for PCI and PCI-X devices you must
disable the devices through the Configuration/Setup Utility program. Start
the Configuration/Setup Utility program and select Start Options from the
main menu. Then, select the Startup Sequence Options and use the
arrow keys to specify the startup order.
v If you plan to install either an optional SCSI adapter or an optional RAID adapter,
you can install it in either of the PCI-X slots if the size of the adapter permits.
The server supports a variety of RAID adapters for both internal and external
configurations. For the most current list of supported RAID adapters, go to
http://www.ibm.com/pc/us/compat/ on the World Wide Web. For details about
installing a RAID adapter, see the documentation that comes with the adapter.
Chapter 4. Customer replaceable units
45