IBM 7379E2U, Инструкция по установке и эксплуатации

Страница: 112 / 152

Completing the installation
To complete the installation, complete the following steps:
1. If the bezel is open, insert the bezel hinges into the slots on the server chassis
and close the bezel.
2. Position the left-side cover over the server.
3. Place the bottom edge of the cover onto the bottom edge of the server.
4. Rotate the top edge of left-side cover toward the server; then, press down on
the cover handle until it clicks into place.
5. Rotate the bezel to its fully closed position.
6. Using the supplied key, lock the left-side cover and bezel.
7. Connect the cables and power cords. For more information, see “Connecting
the cables.”
Connecting the cables
Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
any cables from the server or hot-plug adapter.
2. For additional cabling instructions, see the documentation that comes with the
optional devices. It might be easier for you to route any cables before you install
certain optional devices.
3. Cable identifiers are printed on the cables that come with the server and
optional devices. Use these identifiers to connect the cables to the correct
connectors. For example, the hard disk drive cables are labeled “HDD option.”
96
IBM System x3400 M3 Type 7378/7379: Installation and User's Guide