IBM 7379E2U, Инструкция по установке и эксплуатации

Страница: 119 / 152

- Legacy Thunk Support
Select this choice to enable or disable the UEFI to interact with PCI mass
storage devices that are not UEFI-compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs.
Enabled is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM.
Enabled is the default.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify
whether to use the static IP address or have DHCP assign the IMM IP
address; and save the network changes.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and device drivers in
the server that are compliant with EFI 1.10 and UEFI 2.0.
v
Network
Select this choice to view or configure the network options, such as the iSCSI,
PXE, and network devices. There might be additional configuration choices for
optional network devices that are compliant with UEFI 2.1 and later.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(
hour : minute : second ).
This choice is on the full Setup utility menu only.
v
Start Options
Select this choice to view the startup sequence of system devices.,
This choice is on the full Setup utility menu only.
v
Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, or select a one-time boot. If the server has Wake on LAN hardware
and software and the operating system supports Wake on LAN functions, you
can specify a startup sequence for the WAKE on LAN functions. For example,
you can define a startup sequence that checks for media in a CD-RW/DVD drive,
then checks the hard disk drive, and then the network adapter.
v
System Event Logs
Select this choice to view the system-event log and POST event log. For
information about these logs, see "Event logs" in the
Problem Determination and
Service Guide .
Chapter 3. Configuring the server
103