IBM 4002AC2, Инструкция по установке и эксплуатации

Страница: 37 / 82

General precautions
Attention: Do not install the device in an environment where the operating
ambient temperature might exceed 40°C (104°F).
Make sure that air flow around the front, sides, and back of the device is not
restricted.
Never leave tools inside the device.
Attention: Use the erase startup-config command only for new systems. If you
enter this command on a system you have already configured, the command
erases the configuration. If you accidentally do erase the configuration on a
configured system, enter the write memory command to save the running
configuration to the startupconfig file.
Power precautions
The following precautions apply to B24X devices:
Attention: Make sure you insert the power supply right-side up. It is possible to
insert the supply upside down, although the supply will not engage with the power
backplane cotter pin when plugged upside down. The label of the power supply is
on the top when you plug in the power supply right-side up when the power
connector is on the left and the fan vent is on the right.
Attention: Remove the power cord from a power supply before you install it in or
remove it from the device. Otherwise, the power supply or the device could be
damaged. (The device can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power source.)
Attention: The B24X power supply is designed exclusively for use with B24X
devices. Installing the power supply in a device other than the B24X will cause
extensive damage to your equipment.
CAUTION:
The battery contains lithium. To avoid possible explosion, do not burn or
charge the battery.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the battery
as instructed by local regulations. In the United States, IBM has a process
for the collection of this battery. For information, call 1-800-426-4333. Have
the IBM part number for the battery unit available when you call. (C003)
CAUTION:
Power supplies are hot swappable. However, IBM recommends that you
disconnect the power supply from AC power before installing or removing the
supply. The device can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power
source. Otherwise, you could be injured or the power supply or other parts of
the device could be damaged.
Chapter 2. Installing the B24X
11