IBM 4002AC2, Инструкция по установке и эксплуатации

Страница: 36 / 82

Table 6. Summary of installation tasks (continued)
Task No. Task
Where to Find More
Information
2 Install the device on a
desktop or in an equipment
rack. Devices may also be
wall-mounted. “Installing the device” on
page 12
3 When the device is installed,
plug the power cord into a
nearby power source that
adheres to the regulatory
requirements outlined in this
manual. “Powering on the system” on
page 14
4 Verify that power LED is on
after the system is
powered-on. “Verifying proper operation”
on page 14
5 Attach a terminal or PC to
the device. This enables you
to configure the device
through the Command Line
Interface (CLI). “Attaching a PC or terminal”
on page 15
6 No default password is
assigned to the CLI. For
additional access security,
assign a password. “Assigning permanent
passwords” on page 19
7 Before attaching equipment
to the device, you must
configure an interface IP
address to the subnet on
which it will be located. Initial
IP address configuration is
performed using the CLI with
a direct serial connection. “Configuring IP addresses”
on page 20
8 Once you power-on the
device and assign IP
addresses, the system is
ready to accept network
equipment. “Connecting network devices”
on page 21
9 Test IP connectivity by
pinging other devices and
tracing routes. “Testing connectivity” on
page 24
10 Continue configuration using
the CLI. You also can use
IronView Network Manager to
manage the device. FastIron and TurboIron 24X
Configuration Guide
11 Secure access to the device. FastIron and TurboIron 24X
Configuration Guide
Installation precautions
Attention: Before starting any installation procedure, refer to “Safety notices” on
page xi.
10
IBM x-series of Ethernet Switches Installation and User Guide